The Floor-to-Floor Incline Conveyor (Slider Bed) is a floor-to-floor incline conveyor. It is equipped with an adjustable double nose-over at the discharge end to insure a smooth transfer from the incline to the horizontal plane. Inclines are easily
adjusted up to 30°. This conveyor can also be used as a booster conveyor in gravity flow systems.
3 Belt Widths
Wire Mesh Belt
Adjustable Floor
Supports
BELT - Black Trackmate 447 Roughtop with PVC cover. Clipper unibar lacing. BED - 12 ga. galvanized slider pan, mounted in 6-1/2 in. x 12 ga. powder painted, formed steel channel frame. Standard 4 ft., 6 ft., 8 ft., and 10 ft. Long sections bolt together with splice plates. DOUBLE NOSE-OVER - A 26 in. long horizontal and a 12 in. long nose-over section provides a two-step transition of product from incline to horizontal. Provides up to 30° incline adjustment. LOWER POWERED FEEDER - Chain type driven from tail pulley of inclined conveyor. CENTER DRIVE - Located on the incline section. Chain guard located on left hand side. DRIVE PULLEY - 8 in. dia. with 1-3/16 in. dia. shaft at bearings, machine crowned and fully lagged. TAIL PULLEY - 4 in. dia. with 1 in. dia. shaft at bearings or 6 in. dia. with 1-3/16 in. dia. shaft at bearings, machine crowned. TAKE-UP PULLEY - 4 in. dia. with 1 in. dia. shaft at bearings or 6 in. dia. with 1-3/16 in. dia. shaft at bearings. Machine crowned. TAKE-UP - Take-up in center drive provides 16 in. of belt adjustment. SNUB IDLER/NOSE-OVER ROLLERS - Adjustable 2-1/8 in. dia. or 2-1/2 in. dia. pre-lubricated ball bearings. Snub guards included. RETURN IDLER - Adjustable 1.9 in. dia., pre-lubricated ball bearings. BEARINGS - Sealed, pre-lubricated, self-aligning, ball bearings on drive, tail and take-up pulley. SPEED REDUCTION - Sealed worm gear C-Face speed reducer. No. 50 roller chain to drive pulley. MOTOR - 3/4 HP–230/460V–3 Ph. 60 Hz. Totally enclosed C-Face with brake kit. BELT SPEED - Constant 65 FPM. CAPACITY - Maximum load per linear foot of conveyor 100 lbs.
