The Plastic Belt Conveyor with modular plastic belting uses a positive drive system to eliminate
belt slippage and mistracking.
3 Belt Widths
Wire Mesh Belt
Adjustable Floor
Supports
END DRIVE - Located on discharge end of conveyor. Chain guard located on left hand side. BELT - Polypropylene 2 in. pitch Flush Grid, nominal 1 in. less than BR. BED - UHMW on aluminum slider bars, mounted to frame spacers. Mounted in 7-1/2 in. x 12 ga. powder painted, formed steel channel frame bolted together with butt couplings.
CROSS BRACING - Rods with turnbuckles are fastened to underside of bed
to provide alignment of bed sections to insure correct belt tracking. DRIVE AND TAIL SPROCKETS - 10 tooth 6.4 in. pitch dia. molded plastic sprockets on 1-1/2 in. sq. shaft, 1-3/16 in. dia. shaft at bearings. SNUB ROLLERS - Located at drive and tail ends. RETURN BARS - UHMW on aluminum. BEARINGS - Sealed, pre-lubricated, self-aligning ball bearings on drive and tail shafts. SPEED REDUCTION - Sealed worm gear C-Face speed reducer. No. 50 roller chain to drive sprocket. MOTOR - 1/2 HP–230/460V–3 Ph. 60 Hz. Totally enclosed C-Face. BELT SPEED - Constant 65 FPM. CAPACITY - Maximum load per linear foot of conveyor 200 lbs.
