Design - Engineering - Installation - Maintenance - Service
866-403-5232

Product Catalog » Accumulation Conveyors - Zero Pressure

Drag Chain Conveyor


The Drag Chain Conveyor is a drag chain conveyor designed to handle pallets. Pallets are accumulated with "Zero-Back Pressure," reducing the possibility of collision that may result in product damage.

Accumulation System
11 Widths
Modular Assembly
Adjustable Floor Supports
Electronic Photo Eye

CHAIN
- C-2060H double pitch conveyor chain (straight sidebar).
CHAIN GUIDE - UHMW polyethylene. 
FRAME - 6 in. x 7 ga. powder painted formed steel angle with 1-1/2 in. x 3/16 wall, chain support tube. 4 ga. formed coupling channels located at infeed and discharge ends of each module.
MOTOR - 1-1/2 HP – 230/460V–3 PH. 60 HZ. gearmotor, located underneath in
5 ft. long module.
ACCUMULATION ZONES - 60 in. long.
DRIVE SPROCKETS - Hardened 2060BTB15H with 1-3/8 in. dia. steel shaft.
BEARINGS - Sealed, pre-lubricated, self aligning, ball bearings on drive.
CONVEYING SPEED - 30 FPM.
CAPACITY - 6000 lbs. maximum at 30 FPM (1-1/2 HP maximum). 
ACCUMULATION MODULE - Located in each zone (Diffuse). UL and CSA approved.
AIR REQUIREMENTS - Recommended working pressure 60 P.S.I. Free air consumption at 75 P.S.I. - .50 cu. ft. per actuation for 18" & 21" strand centers - 1.0 cu. ft. per actuation for 24 - 28 strand centers. 
FILTER REGULATOR - Supplied for main air supply line (1/2 in. NPT port).
POWER SUPPLY - 27 VDC, 4 amp Power Supply located near center of conveyor. Maximum of 50 zones per power supply (25 each side of power supply). Requires 120 VAC input.