The Light-Duty Portable Parts Conveyor is easily positioned in or under punch presses, plastic injection molding machines, extruding equipment, and other machinery, where small steel or aluminum stampings, plastic parts, etc., must be quickly conveyed to hoppers or drums to keep production on the move.
6 Belt Widths
One Piece Troughed Bed
Adjustable PCAS Type
OVERHEAD END DRIVE - Located on discharge end of conveyor. Chain guard located on left hand side. BELT - Black Polymate100 RMP COS. Clipper unibar lacing. BED - 12 ga. steel formed troughed bed section with 1 in. high vertical sides. DRIVE PULLEYS - 2-1/2 in. dia. with 1 in. dia. shaft, crowned and fully lagged. TAIL PULLEY - 2-1/8 in. dia. with 7/16 in. dia. threaded shaft. Pre-lubricated ball bearings. RETURN IDLER - Adjustable 1-3/8 in. dia. pre-lubricated ball bearings. TAKE-UP - Screw take-up provided at drive pulley to insure proper belt tension. BEARINGS - Sealed, pre-lubricated ball bearings on drive pulley. SPEED REDUCTION - Sealed worm gear "C" face speed reducer. No. 40 roller chain to drive pulley. MOTOR - 1/2 HP 230/460V 3 Ph. 60 Hz. Totally enclosed fan cooled "C" face. BELT SPEED - Constant 65 FPM. CAPACITY - Maximum load per linear foot of conveyor 10 lbs.
2047 Hwy 96 | Burns, TN 37029 | Ph: 866-403-5232
| Located in Middle Tennessee just 25 minutes West of Nashville, TN
| Serving the following states. Tennessee, North Carolina, South
Carolina, Florida, Georgia, Alabama, Illinois, Indiana, Kentucky,
Louisiana, Oklahoma, Arkansas, Texas.