Design - Engineering - Installation - Maintenance - Service
866-403-5232

Product Catalog » Accessories

Reversing O-Ring Transfer


Reversing O-Ring Transfers are used to move products at right angles to adjacent or parallel conveyor lines. An air bag lifts the transfer mechanism while powered O-Rings transfer the product. Linear bearings are used to guide transfer as it is raised and lowered. Air cylinders operate reversing mechanism to reverse transfer flow.

CAPACITY - 75 lbs. maximum unit load.
TRANSFER O-RING - 3/8" dia. polyurethane o-ring.
TRANSFER SPEED - Same speed as conveyor.
DRIVE - Transfer is driven from line shaft of conveyor.
MOUNTING - Mounted in 36 in. long section with 3 and 4 in. roller centers.
PNEUMATICS - Air bag (controlled by single solenoid valve) lifts transfer. Requires maintained electrical signal of 115V–1 Ph. 60 Hz. from photo cell, limit switch, etc. Transfer will stay in raised position until signal is broken. Current consumption is .09 amps.
AIR REQUIREMENTS - Minimum pressure 60 P.S.I., maximum 100 P.S.I. with .038 cu.ft. of free air per cycle at 60 P.S.I.
Note: To eliminate contaminants in air supply line, a filter-regulator should be installed prior to air valve (not supplied as standard).