Design - Engineering - Installation - Maintenance - Service
866-403-5232

Product Catalog » Accessories

High Speed Pusher


The High Speed Pusher provides high speed automatic product diversion. Product may be diverted 90° onto another conveyor, chute, etc. Special two-valve pneumatic control system provides smoother operation at speeds up to 45 cycles per minute. Cycle time varies with weight of product and stroke.

CAPACITY - 75 lbs. maximum package weight.
CYCLES - Up to 45 times per minute. Cycle rate varies with package weight.
STROKE LENGTH - Available in 14 in. to 18 in., 18 in. to 24 in., or 24 in. to 30 in. ranges.
May be adjusted for any length within each range.
RAM FACE - 12 in., 18 in., or 24 in. wide, with 1 in. thick cushioned pad.
BOW ARM - Tubular steel construction with dogbone wearstrip face.
ELECTRICAL REQUIREMENTS - 120 VAC power supply, 120 VAC pulse actuation signal.
     Note: 24 Volt DC solenoids and switches available.
FILTER REGULATOR, LUBRICATOR (FRL) - Filter, dual regulator, lubricator with safety shut-off valve,
3/8 in. NPT inlet port.
AIR CYLINDER - 1-1/2 in. bore double acting.
AIR VALVES - Double solenoid and single solenoid 4-way valves.
AIR REQUIREMENTS - 40 to 80 PSI. Free air consumption at 60 PSI -.190 cu. ft. per cycle for 14 in. to 18 in. stroke, 247 cu. ft. per cycle for 18 in. to 24 in. stroke, .304 cu. ft. per cycle for 24 in. to 30 in. stroke.
     Note: Include safety factor when calculating compressor size.