Design - Engineering - Installation - Maintenance - Service

Product Catalog » Accessories

Powered Pivot Diverter

The Powered Pivot Diverter is designed for use with accumulating conveyors. Products are automatically diverted onto adjacent 30° spur lines.

CAPACITY - 75 lbs. maximum package weight.
PACKAGE SIZE - Minimum 6 in. wide x 9 in. long, maximum 18 in. wide x 30 in. long. NOTE: Small packages must not be top heavy.
DIVERTER MECHANISM - Two rows of 3-1/8 in. dia. wheels with urethane treads driven by 3/8 in. dia. urethane belts.
CYCLES - Up to 40 times per minute.

DRIVE - 1/2 HP motor with AC type variable speed controller. Select 230V–3 Ph. 60 Hz. or 115V–1 Ph. 60 Hz. power.
AIR CYLINDER - 1-1/4 in. dia. bore x 1 in. stroke, double acting with internal rubber bumpers both ends.
AIR VALVE - Single solenoid 4-way valve with speed controls,1/4 in. NPT valve ports. Requires maintained electrical signal of 115V–1 Ph. 60 Hz. from photo cell, limit switch, etc. Diverter will stay in diverted position until signal is broken. Current consumption is .09 amps holding.
AIR REQUIREMENTS - Minimum pressure 60 P.S.I., maximum 125 P.S.I., free air consumption at 60 P.S.I., .014 cu. ft. per cycle.
Note: To eliminate contaminants in air supply line, a filter-regulator should be installed prior to the air valve (not supplied as standard).